E-Z HEAT AIRCRAFT ENGINE PREHEATER MODEL 470 - 120V
- Stock: In Stock
- Product code: Product cr4745
9,796.00 грн
|
Preheating engines for winter operations is at best a
miserable chore and at worst can be a disaster for the
plane, the pilot & flight operations - until the
development of the E-Z Heat Aircraft Engine Heater. The
E-Z Heat was designed to provide very efficient engine
heating for virtually all propeller driven aircraft.
The heaters consist of a flexible synthetic pad that
easily conforms to the contours of the oil pan. This
pad will heat 12 qts of oil from -40° to +60°F in an
hour while using approximately 300 watts of
electricity. The heater is 1/32" thick. which enables
the immediate heat transfer from heater to engine.
The heaters are thermostatically controlled, so leaving them plugged in overnight means the plane will be ready to go in the morning. Normally, complete pre-heating takes only 3-5 hours for the entire engine to be nice and warm. With this new lighted plug (110V models only, 220V models include no plug to allow for European outlet variance), the owner simply needs to look out the window or peek in the hangar to see if they remembered to plug in their E-Z Heat engine pre-heater. Molded into the male plug end is a newly designed light emitting diode (LED). This LED allows the operator to visually recognize if there is electrical power to the preheat system even from a distance. FAA approved for certificated aircraft. End your cold weather starting problems and reduce premature engine wear. |
| Features |
Installation:
The adhesive is already on the pad. All you need to do is peel and stick it on.
Preheat Time:
3 to 5 hours on cold soaked engine, although, since unit is thermostatically controlled, it may be left on overnight or all the time. Cowl covers and prop covers are recommended for extreme cold weather, they also reduce preheat time.
Lite Brite Plug:
With this new lighted plug, the owner simply has to look out the window or peek in the hangar to see if they remembered to plug in their E-Z Heat engine pre-heater.
Heat Transfer:
Convection/conduction, the safest way of heat transfer available. No flames or glowing elements are potential fire hazards.
The adhesive is already on the pad. All you need to do is peel and stick it on.
Preheat Time:
3 to 5 hours on cold soaked engine, although, since unit is thermostatically controlled, it may be left on overnight or all the time. Cowl covers and prop covers are recommended for extreme cold weather, they also reduce preheat time.
Lite Brite Plug:
With this new lighted plug, the owner simply has to look out the window or peek in the hangar to see if they remembered to plug in their E-Z Heat engine pre-heater.
Heat Transfer:
Convection/conduction, the safest way of heat transfer available. No flames or glowing elements are potential fire hazards.
E-Z HEAT AIRCRAFT ENGINE PREHEATER MODEL 470 - 120V
